What precautions should be taken during the maintenance of gas detectors?
In daily life, try to minimize the one-time charging time as much as possible. When charging, the detector should be turned off to reduce the charging time and extend the service life of the detector. Due to charging being carried out while the device is turned on, the sensor of the detector may be affected by the charger, resulting in sudden alarms or incorrect gas detection.
2. Maintain the dryness of the detector
Under normal circumstances, products including detectors with high application protection levels should pay attention to preventing contact with water, and maintaining the dryness of the detector is an important step that affects the detector. It is stipulated that the application personnel must use a dry towel when wiping to ensure that the instrument is not damp or exposed to moisture. Reasonable and effective prevention of circuit damage.
3. Prevent contact with water
In daily life, many instrument operators use damp towels to wipe the outer shell of the instrument. This is all due to improper maintenance of the detector, which can affect its service life. Once water vapor enters the detector, it can cause damage to the circuit board and affect its accuracy. Similarly, contact with corrosive substances should also be prevented.
4. Prevent collisions and drops
Many operators carry the detector with them during testing under special working conditions, but they do not know that they should choose a suitable location before conducting the testing. They must prevent the detector from falling and colliding in a safe location. Although the detector can resist external forces, frequent collisions and falls can still cause a decrease in sensitivity and affect its service life.
5. Pay attention to regular charging
Sometimes when there is no application of the detector, it is necessary to limit it to the side, which not only does not have a protective effect but also affects its service life. In restricted situations, charging should also be carried out every 2-3 months to protect the normal use of the battery.
