Frequently asked questions about high-frequency soldering stations and quick solutions
A wind gun false trigger:
1. The handle of the ball switch folding air gun should be erected as much as possible.
2. Replace the manual self-locking switch
B soldering station reports an error:
1. The aviation connector is in poor contact, re-plug it.
2. The temperature wire of the thermocouple in the handle is weakly welded, and repair welding is enough.
3. There are burrs or foreign objects in the temperature measuring hole of the soldering iron tip, and the temperature sensing is abnormally lagging behind. Clean it and reinstall it. ,
C Vibration is not activated:
1. Welding of the vibration switch or wire corrosion due to acidic flux, repair welding
2. The most thorough solution is to replace the SW 200D double ball switch.
D Soldering iron tip does not melt tin:
1. In pursuit of low welding, the temperature setting is too low. When using the 4 models attached, it is recommended to set it at 320-350 degrees. If the temperature is too low, the welding time will be too long, and the chance of damage to the parts will increase instead.
2. Improper selection of the soldering iron tip. When using a soldering iron tip such as a curved tip or a knife, the actual temperature of the working surface of the soldering iron tip is far lower than the set temperature because the temperature sensing point is far away from the working end surface and the thermal resistance is too large. Compensation temperature usually needs 50-80 degrees.
