How to extend the service life of a metallographic microscope
Methods to extend the service life of a metallographic microscope: When using the microscope, you should pay attention to the following points: (We only take the use of a metallographic microscope as an example)
1. If conditions permit, it is recommended that your laboratory should have three prevention conditions: shockproof (away from the earthquake source), moistureproof (use air conditioner, dryer), dustproof (floor covered); power supply: 220V±10%, 50HZ ;Temperature: 0°C-40°C.
2. When adjusting the focus, be careful not to let the objective lens touch the sample to avoid scratching the objective lens.
3. Do not switch the objective lens when the center of the round hole of the stage gasket is far away from the center of the objective lens to avoid scratching the objective lens.
4. Do not adjust the brightness from high to low, or too bright, which will affect the service life of the bulb and damage your eyesight.
5. All (function) switching should be done gently and in place.
6. When shutting down, adjust the brightness to minimum.
7. Non-professionals should not adjust the lighting system (filament position lamp) to avoid affecting the imaging quality.
8. When replacing the halogen lamp, pay attention to the high temperature to avoid burns; be careful not to directly touch the glass body of the halogen lamp with your hands.
9. When the power is turned off and not in use, adjust the objective lens to the lowest state through the focusing mechanism.
10. When shut down and not in use, do not cover the dust cover immediately. Wait until it cools down before covering it again. Pay attention to fire prevention. The above points are just some of the things that should be paid special attention to. I hope that everyone should be careful when using the microscope. If you encounter problems when using the microscope that you cannot solve, you can immediately contact the microscope dealer by phone.
