Infrared thermometer tips and tricks for accurate temperature measurement
Infrared thermometer by the optical system, photoelectric detector, signal amplifier and signal processing. Display output and other components. Optical system convergence of its field of view of the target infrared radiation energy, infrared energy focused on the photodetector and transformed into the corresponding electrical signal, the signal is then converted into the temperature value of the target to be measured.
Infrared thermometers provide rapid temperature measurements, and in the time it takes to read a leaking connection with a thermocouple, it is possible to read the temperature of virtually all connections with an infrared thermometer. In addition because the infrared thermometer is solid. Lightweight. (all lighter than 10 ounces) and easy to carry in a holster when not in use. So you can take them with you when you're doing factory tours and daily inspections.
Another advanced feature of infrared thermometers is their accuracy, which is usually within 1 degree. This is especially important when you're doing preventive maintenance, such as monitoring poor production conditions and special events that will result in equipment damage or downtime. Because most equipment and plants run 365 days, downtime equals reduced revenue, and you can prevent such losses by scanning all field electronics - circuit breakers. Transformers. Fuses. Switches. Buses and switchboards for hot spots. With infrared thermometers, you can quickly detect even small changes in operating temperatures and solve problems before they sprout, reducing the expense and scope of repairs caused by equipment failure.
Safety is the most important benefit of using an infrared thermometer. Unlike contact thermometers, which can safely read hard-to-reach or inaccessible target temperatures, you can read the target temperature within the range allowed by the instrument. Non-contact temperature measurements can also be taken in areas that are unsafe or where contact thermometry is more difficult, like near steam valves or heating ovens, and they don't risk burning your fingers if you're not careful when taking contact measurements. Accurate measurement of supply/return air temperatures up to 25 feet above your head is as easy as taking a measurement at hand, and Raytek infrared thermometers are laser sighted for easy identification of the target area. Your job just got a whole lot easier.
Infrared thermometers have proven to be an effective tool for detecting and diagnosing malfunctions in electronic equipment. With an infrared thermometer, you can continuously diagnose electronic connection problems and detect the functional status of an uninterruptible power supply (UPS) by finding hot spots in the output filter connections on DC batteries, you can check battery components and power distribution panel terminals, switch gear or fuse connections to prevent energy consumption; since loose connectors and combinations generate heat, an infrared thermometer helps to identify insulation faults in loop interrupters. Or monitor electronic compressors; daily scanning of transformers for hot spots can detect cracked windings and terminals.
