Measure the voltage of the zero and earth wires with a multimeter
Zero and ground line connection will be reversed how, zero and ground line is through, zero and ground line between the voltage is how many volts related technology articles zero and ground line with a multimeter to measure the voltage of 220V
In the TN-S power supply system, the zero line and the ground line are the same root, are drawn from the neutral ground of the transformer, one to participate in the work circuit, known as the work of the zero line, one as a protection circuit, known as the protection of the zero line.
1, the zero line fire wire reversed
This happens, it is possible that the line is messy, there is no colour distinction between the wires, or dead brains always think that the left zero right fire caused.
Processing method is simple, since there is a multimeter on hand, using a multimeter to measure the resistance between the three lines, voltage, from the new definition of the three lines which is the fire line, which is the zero line, which is the ground line, and make a good mark, the next time you will not make a mistake.
2, the zero line has a broken point
We measure voltage preferably at the power circuit breaker, or if convenient, at the meter. If you measure at the back end of the equipment, there is a possibility that the zero line is broken and a misjudgement occurs.
Zero wire broken at the rear end, then the fire wire and zero wire will be connected through the filament or coil, although there will be some resistance, but basically negligible, the measured voltage does not change much. In this case, we should remove the bulb and other electrical appliances, disconnect the zero wire and fire wire circuit, the measurement will be accurate.
3, the zero line resistance is too large
This situation is basically due to the crimping is not tight, poor contact caused. However, the voltage measured in this case fluctuates, and the wire street will be hot and hot phenomenon.
4, the equipment shell charged
If the equipment shell charged, that is, the fire line leakage, the use of ordinary air switches, leakage current does not reach the short-circuit current, the air switch will not trip. In this case, the measurement of the zero line and the ground line may have 220V voltage.
And Or although the use of leakage protector, but the earth wire broken or ground resistance is too large. This situation occurs leakage, measurement of zero and ground will also have 220V voltage.
5, ground and fire wire reversed
This kind of oddity is difficult to imagine, but to analyse the problem, we also have to consider, do not let go of any doubt.
