Precautions for using soldering iron
1. Setting up the soldering iron before using it.
Before used, the electric soldering iron needs to be tinned. The precise procedure is to heat the electric soldering iron, melt the soldering tin, and then evenly apply a tin wire to the tip of the soldering iron so that it is covered with a thin layer of tin. (Note: Smoking during the heating phase is a typical reaction for a newly purchased soldering iron.)
2. Learn the proper stance for functioning.
It can protect the operator's physical and mental wellbeing and lower workplace accidents. The distance from the soldering iron to the nose should generally be at least 20 cm, and is usually 30 cm, to minimize the harm from chemical substances that volatilize when the flux is heated and to minimize the inhalation of dangerous gases.
3. Verify that the voltage being utilized matches the soldering iron's normal voltage before beginning to solder.
4. The soldering iron needs to be properly grounded.
5. Always wear an electrostatic wristband that is properly grounded when using a soldering iron. (Note: The grounding wires for the soldering iron and the static generator must be kept apart.)
6. The electric soldering iron must not be knocked, disassembled, or installed arbitrarily after it has been powered on.
7. The electric soldering iron needs to be kept dry and shouldn't be used in conditions that are overly muggy or rainy.
8. Turn off the power before removing the soldering iron's tip.
9. After shutting off the electricity, coat the soldering iron's tip with tin to protect it by using the heat that remains.
10. As soon as the soldering iron's tip develops a layer of black oxide, wipe it off with an absorbent sponge and immediately tin it. (Avoid using a knife to scrape)
11. Tin oxides, tin beads, and slag are all collected using the sponge. Simply to get out of the water, it is advised to pinch it with your hands.
12. You shouldn't leave the electric soldering iron on for an extended period of time without using it. This will quickly increase oxidation and limit the life of the soldering iron by causing the core to burn out. The soldering iron tip will also oxidize as a result of the prolonged heating and may even become "burned" and cease to "eat" as a result. tin"
