Repair method for broken electric heating wire of electric soldering iron
The electric heating wire of the electric soldering iron is broken. Two treatment methods are given here. The simple repair method is to splice the fracture. The fast and reliable treatment method is to take the heating wire out of the barrel, first remove the oxide near the fracture, and then tightly Splice. Treatment method for broken electric heating wire of electric soldering iron
The common fault of electric soldering iron is that the heating wire is broken.
1. Simple repair method: Splicing the broken parts, but after this connection, sparks often appear due to loose joints, and the joints break again after a short time. Recommendation: How to use a soldering iron?
2. Quick repair method: take the heating wire out of the cylinder, first remove the oxide near the fracture, and then splice it tightly. : 1 ground), after installation, power on for a few minutes, the powder will melt and adhere to the contacts. In this repair, the contact will not spark, and it is also more durable.
There is a fast and reliable repair method: take the heating wire out of the barrel, first remove the oxide near the fracture, and then twist it tightly, and sprinkle a little mixed powder of glass and electric porcelain around the joint after twisting (mix the two Grinding according to 6:1), after installing, power on for a few minutes, the powder will melt and adhere to the contacts. In this repair, the contact will not spark, and it is also more durable.
