Repair method for broken heating wire of electric soldering iron
Here are two ways to deal with a broken electric soldering iron heating wire. The simple repair method is to splice the broken part. The quick and reliable method is to take the heating wire out of the barrel, first remove the oxide near the break, and then tighten it tightly. splice. How to deal with broken heating wire of electric soldering iron
A common failure of a soldering iron is that the heating wire breaks.
1. Simple repair method: hinge the broken part, but after this connection, sparks often occur due to loose contacts, and after a short time, the contacts break again. Recommended: How to use a soldering iron?
2. Quick repair method: Take out the electric heating wire from the barrel, first remove the oxide near the break, and then splice it tightly. After splicing, sprinkle a little mixed powder of glass and electric porcelain around the joint (press the two to 6 : 1 ground), after installation, power on for a few minutes, the powder will melt and adhere to the contacts. When repaired this way, there will be no sparks in the contacts and it will be more durable.
There is a quick and reliable repair method: take out the heating wire from the barrel, first remove the oxide near the break, and then splice it tightly. After splicing, sprinkle a little mixed powder of glass and electric porcelain around the joint (mix the two Grinded according to 6:1), after installation, power on for a few minutes, the powder will melt and adhere to the contacts. When repaired this way, there will be no sparks in the contacts and it will be more durable.
