The solution to prevent soldering iron from getting stuck in tin
During the lead-free soldering process, there may sometimes be a phenomenon where the soldering iron tip does not adhere to tin. In addition to the quality issues of the soldering iron head itself, there are also reasons for this type of situation, such as choosing a temperature that is too high, which can easily cause severe oxidation of the tin surface of the soldering iron head, incorrect or defective cleaning methods, etc.
The reason and solution for the non tin sticking of the soldering iron tip:
During the lead-free soldering process, there may sometimes be a phenomenon where the soldering iron tip does not adhere to tin. In addition to the quality issues of the electric soldering iron head itself, we can also address these issues from nine other sources
Looking for reasons in terms of aspects:
1. Choosing a temperature that is too high can easily cause severe oxidation on the tin surface of the soldering iron tip.
2. Do not eat tin on the tin coated surface before use.
3. Using incorrect or defective cleaning methods.
4. Use impure solder wire or solder flux interruption in solder wire.
5. When the working temperature exceeds 350 ℃ and welding is stopped for more than 1 hour, the amount of tin on the lead-free soldering iron head is too low.
6. "Dry burning" electric soldering iron tip, such as when the soldering table is not in use and there is no tin on the surface of the soldering iron tip, can cause rapid oxidation of the soldering iron tip.
7. The flux used is highly corrosive, causing rapid oxidation of the soldering iron tip;
8. Using neutral active flux without regularly cleaning the oxide on the soldering iron tip
9. Contact with organic substances such as plastics, lubricants, or other compounds. Common handling methods:
It is to use a small knife to scrape off the oxide layer of the soldering iron tip, exposing copper that has not been oxidized by air. Then, dip it in a rosin box and dip it in tin, and you can use it normally. But this method is not thorough enough to remove, and if scraped for a long time, the soldering iron tip will become thinner, affecting heat transfer, causing a temperature drop, and even damaging the soldering iron tip.
The fast and efficient processing method is:
Grasp the wooden handle of the electric soldering iron, immerse the oxidized soldering iron tip into a container containing alcohol, and after 1-2 minutes, remove it. The oxide is completely and cleanly removed, and the soldering iron tip looks brand new. This is because after heating with copper oxide and alcohol, a chemical reaction occurs, which reduces copper and has no corrosive effect on the soldering iron tip.
