Analysis of how to maintain the inverted metallographic microscope in daily use
1. The surface of the lens must be clean. The dust falling on the surface of the lens can be blown away with an ear-suction ball, or gently dusted off with a soft brush.
2. When there is oil or fingerprints on the surface of the lens, please wipe it with a special solution.
3. Do not wipe the surface of other parts with organic solution, especially plastic parts, you can use a small amount of neutral detergent to wipe with a soft cloth.
4.Do not wipe the lens surface with cotton pads, dry cloth or dry lens paper. Otherwise, do not damage the lens surface, seriously damage the lens, wipe with water. This can leave watermarks on the surface of the lens, allow mold to multiply, and seriously damage the device.
5. It is not allowed to disassemble the equipment at will, especially the intermediate optical system and important mechanical parts, so as not to reduce the performance of the equipment.
6. When the device is not in use, you can leave the eyepiece on the lens barrel, cover the dustproof plug, or cover the device with a dust cover to prevent dust from entering the device.
7. Try not to move the inverted metallurgical microscope, please place it gently when moving to avoid collision.
