How often does it take to replace the sensor of a gas detector?
The question of how often the sensor of a gas detector should be replaced often occurs around us. As long as we use a gas detector, we will face such a problem. So how often should the sensor be replaced?
In fact, there is no recommended maintenance plan for replacing sensors in portable gas detectors. You should not consider replacing the sensor as replacing the gasoline in your car, it is more like filling up the fuel tank. When the sensor does not have sufficient sensitivity to achieve successful calibration, it can be considered that the fuel tank is not full and should be replaced. As long as there is oil in the tank, the sensor can be used normally.
A gas detector has a standard method to confirm the status of the sensor and determine how much oil is still in the tank. It is called retention value. The retention value is a measurement of the sensitivity of the sensor, obtained during the calibration of the detector. At the end of the calibration of the detector, the retained values of each sensor will be displayed and stored in the calibration record of the instrument. When the retention value of the sensor is less than or equal to 50% of the standard gas concentration, the sensor will fail calibration and must be replaced. When the retention value is between 50% and 70% of the standard gas concentration, it indicates that the sensitivity of the sensor is at the edge. At this point, it is possible to consider replacing the sensor to avoid the situation where the fuel tank is completely empty.
So the bottom line should be like this. As long as your sensors have sufficient sensitivity or retention values to successfully calibrate, they can be used normally. It is not necessary to replace the sensor until it fails calibration and cannot be used. Keep an eye on the retention value, so you won't encounter a state where the fuel tank is completely empty.
Here, we would like to remind our friends that gas detectors, as an important alarm device for detecting gas leakage concentration, are of great importance. From the mandatory installation of national laws to the strong requirements of chemical, pharmaceutical and other enterprises, this indicates that we have increasingly attached importance to safety production. Safety is a prerequisite for the stable development of society and the country, and we should cultivate the concept of safety production.
