How to prolong the service life of metallographic microscope
1. If conditions permit, it is recommended that your laboratory should have three anti-conditions: shockproof (away from the source of vibration), moisture-proof (use air conditioner, dryer), dust-proof (floor on the ground); power supply: 220V±10%, 50HZ ;Temperature: 0°C—40°C.
2. When adjusting the focus, be careful not to let the objective lens touch the sample, so as not to scratch the objective lens.
3. When the position of the center of the round hole of the spacer on the stage is far from the center of the objective lens, do not switch the objective lens to avoid scratching the objective lens.
4. Don't adjust the brightness suddenly and suddenly, and don't be too bright, which will affect the service life of the bulb and also damage the eyesight.
5. For all (function) switching, the action should be light and in place.
6. Turn off the brightness to the minimum.
7. Non-professionals should not adjust the lighting system (filament position lamp), so as not to affect the image quality.
8. Pay attention to high temperature when replacing the halogen lamp to avoid burns; be careful not to directly touch the glass body of the halogen lamp with your hands.
9. When the machine is turned off and not in use, adjust the objective lens to the lowest state through the focusing mechanism.
10. When the machine is turned off and not in use, do not cover the dust cover immediately, and cover it after it cools down. Pay attention to fire prevention. The above points are just some places that should be paid special attention. I hope that everyone should be more careful during use. If you really encounter difficulties when using the microscope and cannot solve them by yourself, you can immediately call the microscope merchant to find a solution.
