How to use handheld laser rangefinder
The detection device of the laser range finder (pulse type) generally uses an avalanche photodiode, which is only sensitive to light of a specific wavelength. If the wavelength matches, even a very small light intensity can be detected by it. If the wavelength does not match, even if the light intensity Large and undetectable. The laser just has the characteristics of good monochromaticity, and the commonly used wavelength is 905nm. Therefore, the signal receiving the reflected light is not easily interfered by other wavelengths and intensities of light in the environment. In addition: There are two commonly used laser ranging schemes: pulse method and phase method. The phase method measures the distance by measuring the phase deviation of the returned wave. This needs to cooperate with the target, which is what you call a reflective surface on the measured end. In this case, the transmission power of the range finder is small. The telescopic laser rangefinder used by snipers generally uses the pulse method, that is, a pulse is sent out, the timing is started, and the timing is stopped after receiving the reflected pulse to achieve the purpose of distance measurement. In this case, when there is no cooperative target, the loss of light energy due to diffuse reflection is very serious, but generally it does not affect the measurement. The reason is as mentioned above. Generally, the transmit power of the range finder will be increased to make a certain compensation
