How to use the hot air soldering station
How to use a hot air soldering station. The following is an introduction to how to use the hot air soldering station with an actual example (taking the chip on the motherboard).
(1) Connect to the power supply and turn on the power switch of the hot air soldering station.
(2) Adjust the temperature and wind, the wind is about 3rd gear, and the temperature is about 4th gear.
(3) Move the air gun left and right 3cm above the chip to heat, after the tin point under the chip melts, then use tweezers to pick up the entire chip
(4) After the welding is completed, turn off the power switch of the hot air welding station, because the air gun will continue to spray outward at this time, and then unplug the power of the hot air welding station after the end of the spraying.
When heating the chip, first blow around the chip, lift the middle of the chip, and blow the chip up; do not heat for too long, otherwise the circuit board will be blown.
