The following points should be paid attention to when using the hot air soldering station:
The first time you use hot air welding, you must read the manual carefully; the following are the relevant precautions
(1) The ground wire must be connected to avoid static electricity.
(2) Metal objects cannot be placed in the mesh at the front end of the soldering iron, which may cause damage to the heating element and electric shock to the human body. (HEATER) is adjusted to the middle position to keep the heater in the heat preservation state. When in use, just adjust the hot air volume button and the hot air temperature button.
(3) Inside the hot air welding torch, an automatic overheat protection switch is installed, and the machine stops working when the overheat protection switch of the gun nozzle works. The air volume adjustment button must be adjusted to the maximum, wait for about 2 minutes, the heater will work, and the machine will return to normal. After use, pay attention to cooling the body. After the power is turned off, the heating tube will automatically spray cold air. During this cooling stage, do not unplug the power plug.
(4) After the power switch is turned on, adjust the hot air temperature adjustment button (HEATER) to an appropriate temperature according to different air nozzles and tin suction needles, and then adjust the air volume required by the hot air volume adjustment button, and the preheating temperature can only be used when it reaches the required temperature.
(5) If it is not used for a short time, adjust the hot air volume adjustment knob (AIRCAPACITY) to the minimum, and the hot air temperature adjustment knob adjustment knob (HEATER) to the middle position, so that the heater is in the heat preservation state. When in use, adjust the hot air. Air volume button, hot air temperature button.
(6) Please put the handle on the bracket when not in use to prevent other problems after touching
