Matters needing attention in stereomicroscope
1. The temperature of the microscope installation position shall be between 0 and 40, and the relative temperature shall be less than 85 [%].
2. Stereoscopic microscope should be installed in a place where it will not be disturbed by vibration.
3. Stereoscopic microscope should be installed in a clean and dust-free place.
4. This microscope is a precise optical instrument. Please be careful to protect it from impact and vibration. If it is impacted, vibrated or treated rudely during handling or operation, it will easily damage the instrument.
5. Don't let the lens accumulate dust and leave fingerprints. The stain on the lens will seriously affect the observation of the image. When the lens is dusty, it should be cleaned as follows:
6. Blow it off with a dust blower. If it can't be blown clean, try a soft brush to wipe it off gently.
7. Only when the lens has fingerprints or oil stains, it is necessary to gently wipe off the stains with a clean soft cotton cloth slightly touched with anhydrous alcohol. Don't reuse the same part of cotton cloth.
8. When using the microscope, be sure to handle it with care, and be careful not to touch any optical parts with your hands.
9. Any optical part should be wiped with special mirror wiping paper.
11. When any knob is difficult to turn, you must never use too much force, but check the reasons and remove obstacles.
12. The microscope should be stored in a place where the humidity is low and it should not cause mildew. The microscope should not be stored in a place where it will be directly exposed to the sun and in a place with high temperature and high humidity. During collection, it is advisable to wrap the whole equipment with plastic sheets to prevent dust accumulation.
