Soldering iron head use details
The majority of electronic welding users usually do not pay much attention to the care and maintenance of their soldering iron tips. In fact, the soldering iron is an essential and one of the most commonly used tools for electronic and electrical workers. It is necessary to take good care of it, especially the tip of the soldering iron. You cannot wait until the tip of the soldering iron is too dirty to be used before maintaining it, otherwise there will be problems. The soldering iron may become scrapped.
The main reasons for paying attention to the maintenance of the soldering iron tip are:
(1) If the dirty soldering iron tip is not cleaned and re-tinned in time, it will cause false soldering or
Welding quality problems such as large solder joint burrs.
(2) Because the soldering iron tip is dirty and difficult to weld, the welding time will inevitably be lengthened.
High temperatures over time can cause damage to components such as copper foil and transistors on the circuit board.
(3) The internal heat transfer effect of the dirty soldering iron head is very good, the amount of heat generated is small, and there is
Even the tin cannot be melted.
(4) Severe dirt will cause the fixing screws of the soldering iron head to rust, causing the soldering iron head to become dirty.
The iron head cannot be replaced, causing permanent damage.
In normal use. If unnecessary, try not to let the soldering iron "dry burn" for a long time while it is powered on. When not in use, unplug it in time or place it on a low temperature setting. During use. If you find that the soldering iron tip is slightly dirty, you should dip it in rosin and tin in time to keep the soldering iron tip clean.
Disassemble and assemble the soldering iron head at least once every month, and clean the soldering iron head and interior
Remove the shelled stolen goods from the bottom to prevent the fixing screws from rusting.
