Soldering iron heating core purchase and replacement method
A soldering iron heater is a soldering device component. Soldering iron heating core is able to make the whole soldering iron work up the core, if the soldering iron head does not heat up the soldering iron has lost its role. Heat core is a metal (stainless steel) heat transfer fast, welding temperature changes, ceramic is more resistant to high temperature, temperature control is relatively good, it is recommended to weld small pieces or no long time welding with stainless steel, another for ceramic heat core, large pieces of long time welding can choose to use ceramic.
Soldering iron heating core purchase
1, before buying an assured heating core, first we have to confirm the qualification of this enterprise. Whether it is a well-known company in the country, how is the qualification? How is the user's reputation?
2, the enterprise with what can provide production of a high-performance high-quality heating core to the user? This is to confirm the resources of the enterprise, whether there is strong technical support, generally more than ten years of stable operation.
3, product performance, stable performance, with a customer renewal rate of more than 95 per cent of enterprises, product performance is certainly not bad!
4, product price transparency, not indiscriminate charging, good fear of too expensive, cheap and afraid of bad, so to weigh the cost-effectiveness of the product, the same configuration, the same performance, basically the price plays a decisive role.
5, after-sales service, after-sales service can be done 7 * 24 hours customer service + technical service, timely service in place, the user will be assured.
How to replace the soldering iron heating core
1, first of all, disassemble the soldering iron, the old heating core directly throw away, inside the wire are burned, the plug part is also burned, along with the wire have to be replaced.
2, before the installation of the need to connect the line on the heat insulation sleeve, not readily available to find a section of the isolation of the hot line to unplug the sleeve on.
3, will be connected to the pin first, directly connected to the tight point can not slide, you can use pliers to pinch, sliding is easy to fire and burn off.
4, will insert the pin back to the iron sitting on one end of the joints wrapped in tape insulation, this insulation must be good, and then the new wire soldered to the wire end of the soldering iron seat.
5, are done after the soldering iron recovery on the line, the whole core process is very simple, as long as the insulation is good to deal with no problem, for often electronic production of a good soldering iron is very important.
