Daily maintenance and precautions of Japan ATAGO PAL-1 sugar meter
1. Wipe the sample on the surface of the prism with a paper towel, then drop a few drops of water on the surface of the prism, and clean the surface of the prism and the sample stage with a paper towel. Be careful not to use too much force, or use paper and cloth that are not soft enough to avoid scratching the surface of the prism.
2. If the instrument does not press any key within 5 minutes, it will automatically enter the standby state and the display will be turned off, which is normal.
3. When measuring, avoid direct sunlight on the surface of the prism.
4. If the battery is too low, the screen will display: LLL, at this time, it should be replaced as soon as possible to avoid leakage.
5. It can be washed directly with the slow running water of the tap for a short time (within 10 seconds), but it cannot be soaked in water.
6. Avoid falling and bumping, and pay special attention to installing the battery. Use coins instead of screwdrivers to avoid scratching the battery cover or damaging the threads, which will lose the fixing effect.
7. Plastic shell, avoid using organic solvents.
