Fusing Resistor Test by Multimeter Measurement Method
Selection of Fusing Resistors
Selection should take into account its dual performance, according to the specific requirements of the circuit to select its resistance and power and other parameters. Both to ensure that it can quickly fuse in the overload, but also to ensure that it can work under normal conditions for a long time and stable. Resistance value is too large or too much power, can not play a protective role.
Fusing resistor detection with a multimeter measurement method
In the circuit, when the fuse is open, you can make a judgment based on experience: if you find the surface of the fusing resistor black or burnt, it can be concluded that it is overloaded, the current through it is more than the rated value many times; if the surface of the open circuit without any traces, it shows that the current flowing just equal to or slightly greater than the rated value of the fuse. For the surface of the fusing resistor without any trace of good or bad judgment, with the help of a multimeter r × 1 block to measure, in order to ensure the accuracy of the measurement, the fusing resistor should be welded from the circuit at one end. If the measured resistance to infinity, the fusing resistor has failed open-circuit, if the measured resistance to the nominal value of the difference is very far, indicating that the resistance value, but also should not be used again. Found in the maintenance practice, there are a few fusing resistors in the circuit is broken short-circuit phenomenon, detection should also be noted.
Classification of Fusing Resistors
Fusing resistors can be divided into two types of recoverable fusing resistors and one-time fusing resistors.
(A) Recoverable Fusing Resistors
Recoverable fusing resistor is an ordinary resistor (or resistance wire) with a low melting point solder and spring-loaded metal than (or elastic metal sheet) welded together in series, then sealed in a cylindrical or square shell. The housings are available in metal and clear plastic.
Within the rated current, the recoverable fusing resistor acts as a fixed resistor. When an overcurrent occurs in the circuit, the solder joints of the restorable fusible resistor first melt, disconnecting the spring-loaded wire (or flexible metal sheet) from the resistor. After eliminating the circuit fault, according to the requirements of the resistor and the wire (or metal sheet) welded, you can resume normal use.
Commonly used recoverable fusing resistors are TH series R × 90 series, etc..
(B) One-time Fusing Resistor
Disposable fusing resistor is also called non-recoverable fusing resistor, which plays the role of a fixed resistor in the normal operation of the circuit, when its operating current exceeds the rated current, the fusing resistor will be fused like a fuse to protect the circuit, the disposable fusing resistor can not be repaired after the fusing resistor can only be replaced with a new fusing resistor. Disposable fusing resistors can be divided into wirewound fusing resistors and film fusing resistors according to the materials used in the resistor body.
1. Wirewound Fusing Resistors Wirewound fusing resistors belong to the power type glaze coated resistors, its resistance value is small, usually applied to the circuit with higher operating current.
In the production process, part of the power type glaze coated resistor with fine wire winding or bare part (not coated with glaze protective layer), in the protected circuit overcurrent faults, the resistor's fine wire part or bare part (not coated with glaze part) will burn out due to overheating to protect the circuit.
2. Membrane Fusing ResistorMembrane Fusing Resistor is currently the most used fusing resistor, which is divided into carbon film fusing resistor, metal film fusing resistor and metal oxide film fusing resistor and other kinds of fusing resistor.
