Portable Gas Detector Operating Procedures
With the development of the economy and the improvement of people's living standards, people are also increasingly concerned about health and safety issues, in addition to pay attention to the safety of daily life, food, housing and transportation, the hazards of the gas is also gradually being emphasized, especially industrial toxic and hazardous gases, therefore, many companies have taken a lot of protective measures for the protection of toxic gases, such as the use of portable gas detector on a regular basis on the specific region of the air in the concentration of hazardous gases Detection records, then the portable gas detector operation steps are how?
Step 1: Check the gas detector
In our use of gas detector ready to enter the detection site, we must do the corresponding test of the gas detector, the need to test the gas detector is working properly, such as whether the sensor is normal, whether the power is sufficient, whether a variety of report function is normal, these are all necessary to detect the project, but now many instruments come with the detection function, the boot will be self-test.
Step 2: Determine the location of the detection site
In the use of gas detector into the scene before we need to determine the scene, such as the possible leakage of gas, and we need to detect the gas, according to a variety of gases we do in advance the appropriate protective measures, if it is a toxic gas we need to do a better job of protective measures, such as air respirators, gas masks and so on.
The third step: start testing
After entering the detection site, we need to detect the gas detection in the environment, the portable gas detector probe placed in the environment to be tested, when there is a measured gas leakage, the concentration of the display value becomes larger, when more than the report set value, the report indicator light, while the sound of the report. When the probe moves to the source of the leak, the gas detector concentration display increases, record the reading.
Step 4: Detection is complete
In the environment after the completion of the detection of the various, we need to transmit the detection data to facilitate late research and management, some gas detectors can transmit data directly to the computer and other electronic products through Bluetooth and wireless transmission data, data transmission after the gas detector can be turned off.
Step 5: Charging
When the gas detector power is insufficient, we can not use the gas detector for detection, and gas detector will send out a signal of insufficient power report, this is what we kind of turn off the power and use the charger to charge the battery, each time the charge is about 10-14 hours! To be charged after the completion of can continue to use.
Step 6: maintenance and calibration
Gas detector after use, we should regularly clean the gas detector maintenance, use half a year, a year we should be calibrated to the gas detector, calibration is in order to make the gas detector has no detection error, so you need to calibrate the gas detector on a regular basis.
