What you need to know before using the hot air soldering station
1. Before use, you must read the instructions for use carefully.
2. Before use, the ground wire must be connected in order to discharge static electricity.
3. The front-end mesh of the soldering station must not touch the metal conductor when it is energized. Doing so will cause damage to the heating element and even cause electric shock to the human body.
4. After the power switch is turned on, select different air nozzles and tin suction needles according to needs, and adjust the temperature knob (HEATER) and wind speed knob (AIRCAPACITY) of the hot air soldering station. Just in 4th gear. Users can set it according to the actual situation, but the temperature and wind should not be too high, so as not to burn out the chip or components, and it can be used when the preheating temperature reaches the required temperature.
5. In the process of installing a new chip, there will always be times when the hot air soldering station is not used temporarily. At this time, the hot air temperature knob can be adjusted to the middle position, and the hot air wind force knob can be adjusted to a small state. It can be restored when used again. If it is kept in a high temperature state, it will consume electricity and be dangerous. If the power is turned off, it will cause a lot of trouble.
6. Pay attention to the distance between the nozzle of the air gun and the desoldering. When using a hot air soldering station to disassemble or weld a certain part, do not directly place the tuyere on the part to be desoldered, so as to avoid the high temperature and burn out the part to be desoldered.
7. At the end of use, pay attention to cooling the fuselage, and do not unplug the power quickly after turning off the power. Wait for the short-term cold air blown by the heat pipe to end, so as not to affect the service life of the soldering station.
8. When standing still, put the handle on the bracket to prevent accidents.
