Safety Specifications for High and Low Voltage Clamp Ammeters
1) In any case, special attention should be paid to safety when using this instrument, especially when measuring voltages exceeding AC100V
2) When the voltage is above the line.
3) Due to the malfunction of this instrument, if continued use poses a danger, it should be immediately stopped and sealed, and handled by an authorized and qualified organization.
4) The danger signs on the instrument and manual require users to follow the instructions for safe operation.
5) The extremely dangerous signs in the instrument and manual require users to strictly follow the instructions for safe operation.
6) It is recommended that this instrument undergo insulation strength testing at least once a year. (AC100kV/rms Section 5 Between Insulation Rod and High Voltage Detector Shell)
7) Type B (wireless data transmission type) marked with an asterisk in the manual.
8) If the voltage of the tested line exceeds 600V, it must be connected to an insulating rod for use.
9) Due to the danger of high-voltage power lines, operators must undergo strict training and obtain relevant national certifications
10) High voltage operation certification is required to use this instrument for on-site testing.
11) It is strictly prohibited to use this instrument to test uninsulated wires or busbars.
12) Pay attention to the labeling text and symbols on the dashboard and back panel.
13) Do not place or store instruments in places with high temperature, humidity, condensation, or direct sunlight for a long time.
14) Replace the battery, please pay attention to the polarity of the battery. If the instrument is not used for a long time, please remove the battery.
15) Disassembly and maintenance of this instrument must be carried out by authorized and qualified personnel.
16) If the pliers and other components of this instrument are damaged, please do not use it.
17) Avoid impacting the clamp head and regularly maintain this instrument. Do not use corrosive agents or rough materials to clean. Use a soft cloth (such as eyeglass cloth) dipped in a rust proof and dehumidifying lubricant (such as WD-40), and gently wipe the instrument.
